Getting The Best Swim Spa Cover

Swim Spas represent unique obstacles when it comes to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same reasons a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, eliminating and replacing the cover can be a lot harder.
Getting a brand-new swim spa is an exciting occasion in life. You’re looking forward to the workout you’ll receive from using it. Perhaps you’re a little relieved to have lastly made a selection from the different designs you took a look at. At any rate, you most likely weren’t thinking much about the cover you would use.
Normally, the cover that gets back with your brand-new purchase will be a 4 section stiff foam filled cover that will split in the center and go off both ends.
No big deal.
Up until it begins to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design flaw. Built in obsolescence since as soon as it is placed in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper will not make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are extremely small as they rise from the water surface area. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It happens gradually and on a Swim Spa Cover which is made from specific sections, at varying speeds. So ultimately you’ll notice one or two of the areas are really getting heavy. The bar lifters on completions of the swim spa aren’t much help because you still need to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a different design for their Swim Spa Covers
Instead of using a number of foam panels to develop Swim Spa Covers that will eventually end up in some land fill, they developed one that uses air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate much better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or fall apart at the seams either. So if you own a swim spa, and you intend to keep using it daily, SpaCap.com has the cover for it.
If you’re not all set to buy today, bookmark this site so you can find it once again when you’re prepared!

Leave a Reply

Your email address will not be published. Required fields are marked *