The Challenges to Swim Spa Covers

Swim Spas represent special difficulties when it concerns covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same factors a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, getting rid of and changing the cover can be a lot harder.
Getting a new swim spa is an interesting occasion in life. You’re eagerly anticipating the workout you’ll obtain from using it. Possibly you’re a little relieved to have finally made a selection from the various designs you looked at. At any rate, you most likely weren’t believing much about the cover you would use.
Usually, the cover that comes home with your brand-new purchase will be a 4 area rigid foam filled cover that will split in the center and go off both ends.
No big deal.
Till it starts to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design flaw. Built in obsolescence because as quickly as it is positioned in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper won’t make any difference. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are very little as they increase from the water surface area. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.
It happens gradually and on a Swim Spa Cover which is made of individual sections, at differing speeds. So ultimately you’ll notice one or two of the sections are really getting heavy. The bar lifters on completions of the swim spa aren’t much help because you still need to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a new design for their Swim Spa Covers
Instead of using several foam panels to build Swim Spa Covers that will ultimately wind up in some land fill, they designed one that utilizes air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate much better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these covers won’t fade, or break down at the joints either. So if you own a swim spa, and you plan to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to buy today, bookmark this site so you can discover it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *